Guitarra 1 - toca melodías

Paso 1: Hazlo

¿Qué es?

Play different tunes by using the micro:bit’s touch sensor.

Estos dos vídeos te enseñarán qué vas a hacer y cómo programarlo:

Cómo funciona

• This project is the same as the Jukebox project but instead of using the micro:bit’s buttons, you’ll make your own input device using cardboard covered in strips of tin foil connected by crocodile clip leads to the micro:bit's pins.
• Flash the program onto your micro:bit.
• Attach one end of three crocodile clip leads to pins 1, 2 and GND (ground or Earth pin). Attach the other ends to a cardboard guitar or keyboard.
• With one finger touch the foil connected to GND, and with another finger touch the foil connected to pin 1 and then pin 2. It should play a different tune depending on which strip of foil you touch.
• The micro:bit is using pins 1 and 2 as touch inputs. When you touch either of these pins and the GND pin, you’re completing an electrical circuit. A small amount of electricity flows through you, the micro:bit can detect it and the program triggers the playing of a tune.
• If you do not have a V2 micro:bit, which plays sound, attach headphones to pins 0 and GND.

Qué necesitas

• micro:bit, y opcionalmente, pilas
• Editor de MakeCode o de Python
• three crocodile clip leads
• cardboard, tin foil, glue stick and scissors to make a guitar or keyboard
• optional headphones, buzzer, or speaker with additional two crocodile clip leads for V1 users

Paso 2: Prográmalo

1from microbit import *
2import music
3
4while True:
5    if pin1.is_touched():
6        music.play(music.ODE)
7    if pin2.is_touched():
8        music.play(music.BLUES)
9

Paso 3: Mejóralo

• Change the tunes that are played when you touch the tin foil.
• Programa tus propias melodías.
• Show different pictures, letters, numbers, or words depending on which tune you picked.